Difference between revisions of "BIOMETRICS INSTALLING AND SETTINGS"

Revision as of 13:55, 16 April 2019

I. Biometric Management Tool

*Biometric Management Tool has three steps to make the Biometric Management Tool Service run and it is installing sdk, installing BMT Service - Setting and BMT Service. ALWAYS REMEMBER before launching the system, you should always select RUN AS ADMINISTRATOR to run the system.

II. Installing SDK

• Click “Install SDK” to install.

1. Install SDK – This module will install SDK or the Software Development Kit.
2. Remove SDK – This module removes the Software Development Kit.
3. Reinstall SDK – This module will reinstall the SDK.

• This dialog box will appear after clicking “Install SDK”. Click “Yes” to install and “Cancel” to abort installing SDK.

• After Clicking “Yes” button, the command prompt will pop up and it will notify that installation is successful.

III. Installing BMT Service – Setting

• Click “Install BMT Service” – Setting to install.

IV. Installing BMT Service

• Click “Install BMT Service” to install and run BMT Service.

1. Install BMT Service -  This module should be install before running BMT Service.
2. Remove BMT Service – This module removes BMT Service.
3. Reinstall BMT Service – This module will reinstall the BMT Service.

V. Running BMT Service

• Click “Run BMT Service” and the Biometric Management Tool will activated.

1. Run BMT Service – This module runs the Biometric Management Tool.
2. Stop BMT Service – This module will stop the Biometric Management Tool.
3. Restart BMT Service – This module will restart the Biometric Management Tool.

VI. BMT Service is Running

• If the steps in installing is done and you run the BMT Service, the system will indicate below that BMT Service is Running.

Media:Biometrics Installing.docx